APEC Water Systems RO-LITE-360 Bedienerhandbuch PDF herunterladen (Seite 8)

INSTALLING THE SYSTEM

*All filters are already pre-installed inside their housings, please follow the installation steps listed

below.

The Ro Lite Commercial system can be installed in any location where there is a cold water supply with suffi-

cient water pressure for your chosen RO model, and an outlet to drain off the waste water generated by the

system. A sheltered environment is recommended to avoid any exposure to hot and cold weather or under

direct sunlight.

Step 1: Feed Water Connection

The Ro system must be connected to the COLD water supply only!

The Ro’s feed water adaptor fits a 1/2” pipe. If you need to cut the pipe, using a qualified plumber is highly

recommended.

The instructions below are for “under-sink” installation.

1. For under-sink hook up: Locate the Cold water supply valve under the sink. Turn OFF the incoming

cold water completely.

Note: If the cold water shut off valve is unable to turn off the water, the main water supply to

the house must be shut off for the installation.

Be sure to use Teflon Tape on all metal connections to prevent leaks!

2. For Flex Line Riser: See Fig. 2A. Loosen nut and separate cold water riser tube from faucet shank.

Gently bend riser tube so that the Feed Water Adapter (Fig.5) fits onto the faucet shank. Fit the new cone

washer provided in the kit onto the riser tube. Connect the riser tube, the feed water adapter, and faucet

shank together and tighten. Use Teflon tape on threaded parts to prevent leaks.

For Solid Copper Riser: See Fig. 2B. Follow the same procedure as for flex line. If the copper riser

cannot bend, then it’s best to replace it with a flex line riser. Then fit the feed water adaptor the same way

as described above. Use Teflon tape to prevent leaks.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Keine Kommentare

APEC Water Systems RO-LITE-360 Bedienerhandbuch Seite 8